2006-2011 Camry Aurion · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2006


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.
    If the engine oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not add engine oil above the full level mark.


CHECK ENGINE OIL QUALITY
  1. Check the engine oil for deterioration, water contamination, discoloring or thinning.
    If the oil is bad, replace the engine oil and engine oil filter.


CHECK OIL PRESSURE
  1. Remove the engine under cover LH.

  1. Remove the engine under cover RH.

  1. Disconnect the oil pressure switch connector.

  1. A160879
    Using a 24 mm deep socket wrench, remove the oil pressure switch.

  1. A160880
    Install the oil pressure gauge with adapter.

  1. Warm up the engine.

  1. Check the oil pressure.

    Standard oil pressure:
    Engine Condition
    Oil Pressure
    Idle
    80 kPa (0.8 kgf*cm2, 11.6 psi) or more
    3000 rpm
    380 kPa (3.9 kgf*cm2, 55.5 psi) or more

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. A050082E14
    Remove the oil pressure gauge.

  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. A160879
    Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine within 1 hour after installation.

  1. Connect the oil pressure switch connector.

  1. Check for engine oil leaks.

  1. Install the engine under cover RH.

  1. Install the engine under cover LH.

← INSTALLATION (from Jun 2006)COMPONENTS (from Oct 2006) →